Siemens SENTRON PAC3200 - Page 7

Table of contents
SENTRON PAC3200
Manual, 02/2008, A5E01168664B-04
7
Table 8-2 Assignments of the function keys in the "SETTINGS" menu.....................................................115
Table 8-3 Assignments of the function keys in the device settings display ...............................................116
Table 8-4 Assignments of the function keys in edit mode of the device settings.......................................117
Table 11-1 AC/DC multi-range power supply...............................................................................................159
Table 11-2 Extra-low voltage DC power supply:..........................................................................................159
Table A-1 Errors, comments, and suggestions for improvements .............................................................172
Table B-1 Protective measures ..................................................................................................................174
Table C-1 Meaning of abbreviations...........................................................................................................175
Figures
Figure 2-1
Safety-related symbols on the device..........................................................................................18
Figure 3-1 Overload display ..........................................................................................................................25
Figure 3-2 Display of the measured voltage in the case of connection type 3P4W......................................26
Figure 3-3 Display of the measured voltage in the case of connection type 1P2W......................................26
Figure 3-4 "LIMIT LOGIC" device setting ......................................................................................................34
Figure 3-5 Representation of limit violations .................................................................................................35
Figure 3-6 Energy pulse output .....................................................................................................................36
Figure 3-7 Pulse length and turn-off time......................................................................................................37
Figure 3-8 "COMMUNICATION" device setting ............................................................................................38
Figure 3-9 Enter IP address ..........................................................................................................................39
Figure 3-10 Typical display with entered values .............................................................................................39
Figure 3-11 Switching the protocol to MODBUS TCP.....................................................................................39
Figure 3-12 Restart prompt .............................................................................................................................39
Figure 3-13 SENTRON PAC3200 with screw terminals, rear .........................................................................63
Figure 3-14 Not available for use! Slot for memory card and battery compartment .......................................64
Figure 4-1 Mounting position.........................................................................................................................65
Figure 5-1 Installation step E - Strain relief for RJ45 connector ...................................................................71
Figure 5-2 Deinstallation, releasing the locking hooks..................................................................................72
Figure 6-1 Connection designations, view of the rear and top of the device with screw terminals...............75
Figure 6-2 Connection designations, view of the rear and top of the device with ring lug terminals ............76
Figure 6-3 Terminal labeling with screw terminals ........................................................................................77
Figure 6-4 Labeling of the ring lug terminals.................................................................................................78
Figure 6-5 Terminal block: digital input and output, reference potential .......................................................79
Figure 6-6 Connecting cables to the screw terminal .....................................................................................81
Figure 6-7 Connecting the cables to the ring lug terminals:..........................................................................82