Glossary
Distributed I/O system
302 System Manual, 12/2016, A5E03576849-AG
Communication concept for the realization of modular, distributed applications within the
scope of PROFINET.
Distributed field device that can be assigned to one or more IO controllers (e.g. distributed
I/O system, valve terminals, frequency converters, switches).
Safety-oriented PROFINET I/O bus profile for communication between the → safety program
and the → F-I/O module in a → fail-safe system.
The PROFIsafe address (code name according to IEC 61784-3-3: 2010) is used to protect
standard addressing mechanisms such as IP addresses. The PROFIsafe address consists
of the F-source address and F-destination address. Every → fail-safe module therefore has
two address portions, the F-source address and the F-destination address.
The PROFIsafe address must be configured in the hardware and network editor.
PROFIsafe monitoring time
Monitoring time for safety-related communication between the F-CPU and F-I/O
Period after which a component must be forced to fail-safe state, that is, it is either replaced
with an unused component, or is proven faultless.
Provider-Consumer principle
Principle of data communication on the PROFINET IO: in contrast to PROFIBUS, both
parties are independent providers when sending data.
→ M-switch
Push-in connections are a form of spring-loaded terminals allowing wiring without tools for
rigid conductors or conductors equipped with end sleeves.
To Next Page
Loading...
