Expanding and assigning parameters to the device
6.4 Drives (HDD/SSD)
SIMATIC IPC347G
Operating Instructions, 10/2020, A5E50059993-AA
53
Procedure
1. Remove the drive module (Page 51).
2. Secure the hard disk in the corresponding slot.
If you want to install a 2.5" hard disk drive or 3.5" hard disk drive, you need to install a
corresponding converter in addition.
Recommend installing the hard disk in the middle slot of the drive module.
3. Install the driver cage again.
4. Connect the power and data cables to the drive.
5. Install the drive bay according to the reverse steps of removing the drive bay.
To Next Page
Loading...
