Siemens SIMATIC IPC347G

Expanding and assigning parameters to the device
6.4 Drives (HDD/SSD)
SIMATIC IPC347G
54 Operating Instructions, 10/2020, A5E50059993-AA
6.4.4 Removing and installing internal HDD/SSD
Requirement
• The device is fully disconnected from the line voltage, see "Switching off the device
(Page 40)".
• The device is open, see important information in "Open the device (Page 44)".
• The drive bay is taken out of the chassis.
Procedure
Loosen the four screws ① on the drive bay plate and remove the hard disk from the drive
bay.
Procedure for installing the hard disk drive
Place the hard disk onto the drive bay plate and secure the drive with four screws ①.