Siemens SIMATIC IPC347G User Manual

Standards and approvals
SIMATIC IPC347G
Operating Instructions, 10/2020, A5E50059993-AA
81
UL approval
The following approvals are available for the device:
• Underwriters Laboratories (UL) in accordance with Standard UL61010-1 and UL61010-2-
201 (IND.CONT.EQ), File E472609
• Canadian National Standard CAN/CSA No.61010-1-12 and CAN/CSA C22.2 No.61010-2-
201
FCC and Canada
USA
Federal Communica-
tions Commission
Radio Frequency Inter-
ference Statement
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communica-
tions. Operation of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own expense.
Shielded Cables
Shielded cables must be used with this equipment to maintain compliance with FCC regulations.
Modifications
Changes or modifications not expressly approved by the manufacturer could void the user’s au-
thority to operate the equipment.
Conditions of Opera-
tions
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two con-
ditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
CANADA
Canadian Notice
This Class B digital apparatus complies with Canadian ICES-003.
Avis Canadien
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Responsible party for Supplier's Declaration of Conformity
Siemens Industry, Inc.
Digital Factory - Factory Automation
5300 Triangle Parkway, Suite 100
Norcross, GA 30092
USA
Mail to: (amps.automation@siemens.com
)
AUSTRALIA / NEW ZEALAND
This product meets the requirements of the standard EN 61000-6-3 Generic standards -
Emission standard for residential, commercial and light-industrial environments.
This product meets the requirements of the standard EN 61000-6-3 Generic standards -
Emission standard for residential, commercial and light-industrial environments.

Siemens SIMATIC IPC347G Specifications

General

Brand	Siemens
Model	SIMATIC IPC347G
Category	Industrial PC
Language	English