Siemens SIMATIC S5 - Page 18

R 02/92
General Function Description
I
Note 1 (for positive values):
I
Id
Total track area
m
loo~,oo
I
I
I
i
i
[
+ lncreasing~values
I
Traversing direction
I
YI
I
I
h
Decreasinalvalues
—
I
I T
raversing direction
66 ,,
1
“o”
Track identifier bit (A= 100, E = 200)
“
,,
1
Track identifier bit (E = 100, A = 200)
“o”
99
100
199
Aside from the traversing direction the following applies:
When the first cam value in traversing direction is reached, the track identifier bit is set (or reset
respectively).
When the cam end is reached in the same direction, the track identifier bit by then is already reset
(or set respectively).
tions, the end value (or the initial value respectively) must be increased by one.
1–9
1P 241 Equipment Manual
@ SiemenS AG 1989, Order No: 6ES5 998-0KD21
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com