Siemens SIMOCODE pro User Manual

Block icons and faceplate views
3.2 Faceplates
SIMOCODE pro PCS 7 Library V9.0
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
59
Overview window
The overview window shows the overall status of the block:
①
Group display:
Indicates whether unacknowledged alarms and warnings are pending.
②
LOCK status for messages, authorization level 5 and higher
③
Message suppression
④
Message acknowledgement, authorization level 5 and higher
⑤
Occupied - Batch:
This function indicates whether the block instance of SIMATIC BATCH is assigned.
⑥
Signal status of the block
⑦
Reserved
Expanded command area
For inputs in the dialog window that require confirmation by the operator, the command area
is expanded in the faceplate. The corresponding options are then available, depending on
the selection.
Figure 3-2 Example of expanded command area
The expanded command area can be programmed with a 2- or 3-level access concept for
the operator. The access can be changed in the WinCC Explorer using the internal
@APLCommandExecutionSteps variable.
Level 2: The operator only needs to press the command to execute.
Level 3: The operator must also press the OK button to execute the command.

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000