Siemens SIMOCODE pro User Manual

Block icons and faceplate views
3.2 Faceplates
SIMOCODE pro PCS 7 Library V9.0
60 Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
Authorization levels
Some commands are subject to permission with authorization levels via WinCC. The
authorization levels are updated when a view is opened. The user can only execute the
commands that are enabled for him.
The authorization levels are created for the project by means of a user ID.
Figure 3-3 Assigning authorization levels in WinCC
Reference
The configuration of faceplates and icons follow the standards of the Advanced Process
Library.
For more information about this and authorization levels, refer to Function Manual "Process
Control System PCS7, PCS7 Advanced Process Library V9" on the Internet
(https://support.industry.siemens.com/cs/ww/en/view/109482346
).

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000