Siemens SIMODRIVE 611 universal - Page 313

5
5.9 Parameter overview of PROFIBUS–DP
5-313
 Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
 P0600 Operating display
 P0607 Analog setpoint, terminal 56.x/14.x
 P0612 Analog setpoint, terminal 24.x/20.x
 P0653 Image, input signals, Part 1
 P0654 Image, input signals, Part 2
 P0656 Image, output signals, Part 1
 P0657 Image, output signals, Part 2
 P0658 Image, output signals, Part 3
 P0660 Function, input terminal I0.x
 P0661 Function, input terminal I1.x
 P0662 Function, input terminal I2.x
 P0663 Function, input terminal I3.x
 P0680 Function, output terminal O0.x
 P0681 Function, output terminal O1.x
 P0682 Function, output terminal O2.x
 P0683 Function, output terminal O3.x
 P0972 Request POWER–ON RESET (from SW 3.3)
 P1012.2 Function switch
Bit 2 ”Ready or no fault”
 P1012.12 Function switch
Bit 12 ”power–on inhibit”
 P1795 Optional module (PROFIBUS): Firmware version
Additional
parameters
relevant for
PROFIBUS–DP
(refer to Chapter
A.1)
5 Communications via PROFIBUS DP
08.99
05.00