Siemens SIMODRIVE 611 universal - Page 583

6
6.11 Motor changeover for induction motors (from SW 2.4)
6-583
 Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
Table 6-61 Motor data set–dependent parameters, continued
Motor data set Meaning
1432
1400 2400 3400 4400 Rated motor speed
1401:8 2401:8 3401:8 4401:8 Speed for the max. useful motor speed
1403 2403 3403 4403 Shutdown speed, pulse cancellation
1405:8 2405:8 3405:8 4405:8 Monitoring speed, motor
1407:8 2407:8 3407:8 4407:8 P gain of speed controller
1408:8 2408:8 3408:8 4408:8 P gain, upper adaptation speed
1409:8 2409:8 3409:8 4409:8 Integral action time, speed controller
1410:8 2410:8 3410:8 4410:8 Integral action time, upper adaptation speed
1411 2411 3411 4411 Lower adaptation speed
1412 2412 3412 4412 Upper adaptation speed
1413 2413 3413 4413 Select adaptation, speed controller
1417:8 2417:8 3417:8 4417:8 nx for ”nact < nx” signal
1418:8 2418:8 3418:8 4418:8 nmin for ”nact < nmin” signal
1426:8 2426:8 3426:8 4426:8 Tolerance bandwidth for ”nset = nact” signal
1451:8 2451:8 3451:8 4451:8 P gain, speed controller IM
1453:8 2453:8 3453:8 4453:8 Integral action time, speed controller IM
1458 2458 3458 4458 Current setpoint, open–loop controlled range IM
1459 2459 3459 4459 Torque smoothing time constant IM
1465 2465 3465 4465 Changeover speed, MSD/IM
1466 2466 3466 4466 Changeover speed, closed–loop/open–loop control IM
1602 2602 3602 4602 Warning threshold, motor overtemperature
1607 2607 3607 4607 Shutdown limit, motor temperature
1608 2608 3608 4608 Fixed temperature
1712
1)
2712
1)
3712
1)
4712
1)
Weighting, rotor flux representation
1713
1)
2713
1)
3713
1)
4713
1)
Weighting, torque representation
1725
1)
2725
1)
3725
1)
4725
1)
Normalization, torque setpoint
1) These parameters are read–only.
6 Description of the Functions
01.99
04.99
! not 611ue !