Tool offsets
7.4 Online tool offset (PUTFTOCF, FCTDEF, PUTFTOC, FTOCON, FTOCOF)
Job planning
406 Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
Call the "Continuous non-modal write of online tool offset" function
Parameter:
Number of the polynomial function
Type: INT
<function>:
Note:
Must match the setting for
FCTDEF.
Variable reference value from which the offset is
to be derived (e.g. changing actual value).
<reference value>:
Type: VAR REAL
Number of the wear parameter (length 1, 2 or 3)
in which the offset value is to be added.
<tool parameter:
Type: INT
Number of the channel in which the online tool
offset is to take effect.
Type: INT
<channel>:
Note:
A channel number only has to be specified if the
offset is not to take effect in the active channel.
Number of the spindle for which the online tool
offset is to take effect.
Type: INT
PUTFTOCF:
<spindle>:
Note:
A spindle number only has to be specified if the
offset is to be applied to a non-active grinding
wheel rather than the active tool which is
currently in use.
Call the "Discrete write of online tool offset" function.
Parameter:
Offset value to be added in the wear parameter.
<offset value>:
Type: REAL
<tool parameter>: See PUTFTOCF
Number of the channel in which the online tool
offset is to take effect.
<channel>:
Type: INT
PUTFTOC:
<spindle>: See PUTFTOCF
To Next Page
Loading...
Need help?
General
