Siemens SINUMERIK 828D - Page 727

Tables
16.1 Instructions
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
727
Operation Meaning W
1)
Description see
2)
FLIN Feed linear variable m PGAsl
Feedrate response (FNORM, FLIN, FCUB, FPO)
(Page 458)
FMA Multiple feedrates axial m PGsl
FNORM
3)
Feedrate normal to DIN 66025 m PGAsl
Feedrate response (FNORM, FLIN, FCUB, FPO)
(Page 458)
FOCOF Deactivate travel with limited
torque/force
m PGAsl
Travel to fixed stop (FXS, FXST, FXSW, FOCON,
FOCOF) (Page
613)
FOCON Activate travel with limited torque/force m PGAsl
Travel to fixed stop (FXS, FXST, FXSW, FOCON,
FOCOF) (Page
613)
FOR Counter loop with fixed number of
passes
PGAsl
Count loop (FOR ... TO ..., ENDFOR) (Page 102)
FP Fixed point: Number of fixed point to be
approached
s PGsl
FPO Feedrate characteristic programmed via
a polynomial
PGAsl
Feedrate response (FNORM, FLIN, FCUB, FPO)
(Page 458)
FPR Rotary axis identifier PGsl
FPRAOF Deactivate revolutional feedrate PGsl
FPRAON Activate revolutional feedrate PGsl
FRAME Data type for the definition of coordinate
systems
PGAsl
Defining new frames (DEF FRAME) (Page 292)
FRC Feedrate for radius and chamfer s PGsl
FRCM Feedrate for radius and chamfer, modal m PGsl
FROM The action is executed if the condition is
fulfilled once and as long as the
synchronized action is active
PGAsl
Cyclically checking the condition (WHEN,
WHENEVER, FROM, EVERY) (Page 553)
FTOC Change fine tool offset PGAsl
Online tool offset (FTOC) (Page 589)
FTOCOF
3)
Online fine tool offset OFF m PGAsl
Online tool offset (PUTFTOCF, FCTDEF, PUTFTOC,
FTOCON, FTOCOF) (Page
404)
FTOCON Online fine tool offset ON m PGAsl
Online tool offset (PUTFTOCF, FCTDEF, PUTFTOC,
FTOCON, FTOCOF) (Page
404)