Tables
16.1 Instructions
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
745
Operation Meaning W
1)
Description see
2)
PREPRO Identify subprograms with preparation
PGAsl
Identifying subprograms with preparation (PREPRO)
(Page 171)
PRESETON Set actual values for programmed axes
PGAsl
Preset offset (PRESETON) (Page 296)
PRIO Keyword for setting the priority for
interrupt processing
PGAsl
Assign and start interrupt routine (SETINT, PRIO,
BLSYNC) (Page 114)
PROC First operation in a program
PGAsl
Calling subroutine with path specification and
parameters (PCALL) (Page
193)
PTP Point-to-point motion m
PGAsl
Cartesian PTP travel (Page 377)
PTPG0 Point-to-point motion only with G0,
otherwise CP
m
PGAsl
PTP for TRANSMIT (Page 381)
PUNCHACC Travel-dependent acceleration for
nibbling
PGAsl
Punching and nibbling on or off (SPOF, SON, PON,
SONS, PONS, PDELAYON, PDELAYOF, PUNCHACC)
(Page 647)
PUTFTOC Tool fine offset for parallel dressing
PGAsl
Online tool offset (PUTFTOCF, FCTDEF, PUTFTOC,
FTOCON, FTOCOF) (Page 404)
PUTFTOCF Tool fine offset dependent on a function
for parallel dressing defined with
FCTDEF
PGAsl
Online tool offset (PUTFTOCF, FCTDEF, PUTFTOC,
FTOCON, FTOCOF) (Page 404)
PW B spline, point weight s
PGAsl
Spline interpolation (ASPLINE, BSPLINE, CSPLINE,
BAUTO, BNAT, BTAN, EAUTO, ENAT, ETAN, PW, SD,
PL) (Page 234)
QECLRNOF Quadrant error compensation learning
OFF
PGAsl
Learn compensation characteristics (QECLRNON,
QECLRNOF) (Page
680)
QECLRNON Quadrant error compensation learning
ON
PGAsl
Learn compensation characteristics (QECLRNON,
QECLRNOF) (Page
680)
QU Fast additional
(auxiliary) function output
PGsl
R... Arithmetic parameter also as settable
address identifier and with numerical
extension
PGAsl
Predefined user variables: Arithmetic parameters (R)
(Page 19)
RAC Absolute non-modal axis-specific radius
programming
s
PGsl
RDISABLE Read-in disable
PGAsl
Set read-in disable (RDISABLE) (Page 577)
To Next Page
Loading...
