5 Operation
5.3 Selection mode
Manual
SIPART DR21
C73000-B7476-C143-08
153
Exit key (16)
1)
bLb = 1 or bLPS = 1
bLPS = 0
Enter key (11)
Shift key (6)
up to approx. 5 s
Process operation mode
Operating and Monitoring
bLb = 0
onPA
Exit-
key (16)
PS in the
y display flashes
Online-parameters
see chapter 5.4.2, page 155
Adaptation
see chapter 5.4.3, page 156
Parameterization mode (online)
AdAP, only appears
at S48 > 0
bLb or bLPS in the w/x-display,
PS in the y display flashes
At bLb = 1 no operation
at all is possible.
oFPA
BLS = 1
BLS = 0
StrS
CAE3, only appears
at S6 > 3
APSt
Δw key (14, 15)
Δw key (14, 15)
Δw key (14, 15)
Δw key (14, 15)
Selection mode
Offine parameters
see
chapter 5.4.4, page 163
Structure switches
see chapter 5.4.5, page 165
CAE-menu
see chapter 5.4.6, page 173
All Preset (sets controller to
factory setting)
see chapter 5.4.7, page 178
Enter key (11)
Exit key (16)
Exit key (16)
Exit key (16)
Exit key (16)
Exit key (16)
Structuring modes (offline)
Release of the
Shift key (6)
Enter key (11)
up to (approx. 3 s)
Enter key (11)
up to (approx. 3 s)
Enter key (11)
up to (approx. 3 s)
Enter key (11)
up to (approx. 3 s)
Δw key (14, 15)
Δw key (14, 15)
1)
automatic return if there is no Enter function to a parameterization- or structuring mode within 20 s.
Figure 5-2 Overview selection mode