5 Operation
5.4 Configuration modes
Manual
158
SIPART DR21
C73000-B7476-C143-08
Automatic abortion is effected by the error monitors (see table 5-3, page 162). The error
messages are displayed on the digital w/xdisplay. The error message is acknowledged by
pressing the Enter key (11), the configuration mode AdAP is retained, tU is displayed, the
presettings can be corrected if necessary. The adaptation is aborted by the signals N (DDC),
Si and ±yBL. Abortion by the SES control signals N
ES
(DDC), Si
ES
,±yBL
ES
canbepre-
vented by Internal operation.
To Next Page
Loading...
Need help?
General
