Siemens SIPART DR21 User Manual

6 Commissioning
6.5 Automatic setting of control parameters by the adaptationmethod
Manual
188
SIPART DR21
C73000-B7476-C143-08
Process opera- tion-level
bLb = 0, bLPS = 0
Shift key press for about 5 s
Selection- level
+
-
onPA
AdAP
Configuration level AdAP
Pre-adaptation ↗ Pre-settings Adaptation LED (19) off
(6)
Exit (16)
Enter (11)
Exit (16)
Δw-
keys (14), (15)
During adaptation Adaptation LED (19) flashing Complete process display
Start of adaptation Enter key (11)
1)
xx = manipulated variable
old para-- meter- values are retained
new parameter- values are provided for transfer
Enter (11)
Error message acknowledge
Adaptation repeat
Aborted adaptation Adaptation LED (19) off
by errors in the adap- tation method see table 5-3, page 162
manually by Exit key
Error message Exit AdAP for error c orrection
Switch controller to automatic mode, new parameters are effective
Old parameters are overwritten by new parame- ters Switch controller to manual mode, set desired operating point and wait for stationary condi- tion.
tU 0FF,0.1to24h dPv nEG, PoS dY 0,5to90% xx
1)
Strt
w cP tn tv AH xx
1)
Strt Old values can only be set in onPA configu- ration level
Post adaptation Adaptation LED (19) on
vv cP tn tv AH
new parame- ter values can be chan- ged with Δw-keys (14), (15)
Pi..x Pid.x
2)
Parameter select- able with Δy-keys (7), (8) 2)
Parameter set selectable with Δw-keys (14), (15)
Figure 6-1 Overview configuration level AdAP

Siemens SIPART DR21 Specifications

General

Brand	Siemens
Model	SIPART DR21
Category	Controller
Language	English