Siemens SIRIUS 3RW44 - Integration into the User Program; Introduction; PROFIBUS DP Commissioning Using the GSD File in STEP 7 (Example); Switching on

PROFIBUS DP Communication Module
SIRIUS 3RW44 manual
GWA 4NEB 535 2195-02 DS 06
8-17
8.6 PROFIBUS DP Commissioning using the GSD File in STEP 7
(Example)
8.6.1 Introduction
The following example shows you how to commission the PROFIBUS DP
communication module.
• Installation and activation of the PROFIBUS DP communication module (field
bus interface)
• Configuration with STEP 7 using the GSD file
• Integration into the user program
• Switching on
Necessary components
• 3RW44 soft starter
• 3RW49 00-0KC00 communication module
General prerequisites
• You have configured an infeed module with integrated S7 station
e.g. with CPU315-2 DP.
• You are proficient in STEP 7.
• The PD is connected to the DP master.
Software prerequisites
Table 8-1: Software prerequisites for commissioning
Configuration
software used
Version Explanations
STEP 7 From
version
V5.1+SP2
onwards
You have integrated the GSD file of the soft starter
into STEP 7.
Configuration software
for the different DP
master used
You have integrated the GSD file of the soft starter
into the respective configuration tool.