Siemens SIRIUS 3RW44 - Activating the PROFIBUS DP Communication Module Via the Display, Setting the Station; Address and Saving the Settings

PROFIBUS DP Communication Module
SIRIUS 3RW44 manual
8-10 GWA 4NEB 535 2195-02 DS 06
8.4.2 Activating the PROFIBUS DP Communication Module via the Display, Setting the Station
Address and Saving the Settings
1. When putting the soft starter into operation for the first time, you have to go
through the quick start menu (refer to Chapter 5.2). Also refer to the operating
instructions "3RW44 Soft Starters" (order number: 3ZX1012-0RW44-0AA0).
2. Press the respectively marked key on the device.
3. The "BUS" LED blinks red.
4. When the PROFIBUS icon appears on the display, the PROFIBUS DP
communication module has been activated successfully.
Status
select
2
display
select
Settings
select
3
select
Parameter
select
1
select
set 1
Saving
select
11
select
options
Fieldbus
select
10
select
Fieldbus
select
1
change
interface
Off
select select
Fieldbus interface
1
2
On
Off
select select
Fieldbus interface
1
2
On
Off
Fieldbus
select
1
change
interface
On
Display mea-
select
1
sured value
select
1
SIEMENS
Menu
3RW44
ESC OK
ESC OK
ESC OK
ESC OK
ESC OK
ESC OK
ESC OK
ESC OK
ESC OK
ESC OK
ESC OK