Display, Controls and Device Interfaces
SIRIUS 3RW44 manual
4-2 GWA 4NEB 535 2195-02 DS 06
4.1 Display and Controls
Graphic display A graphic display on the front of the device provides information about the
functions and status of the soft starter via plain text and symbols when control
voltage is applied.
Figure 4-1: Explanation of symbols
Controls There are four keys for operating and adjusting the soft starter:
The current function, depending on the menu item, is shown as text on the
display above this key (e.g. select menu, change value or save settings).
The up/down arrow keys are used to navigate through the menu items or to
change number values in the settings menu item.
The ESC key is used to quit the current menu item and to jump back to the
higher-level menu item.
1 2 3
1. Displays the control unit
that has current control
priority, i.e. that sends the
control commands for the
motor.
Display with keys
Serial interface
Control inputs
PLC via PROFIBUS
PC via bus
No control device
2. Displays the defined
user level.
Customer read
only
Customer write
3. Displays the current
motor status.
No motor
Run up
Motor running
Coasting down
Motor ready to
start
To Next Page
Loading...
