Siemens SIRIUS 3RW44 - Page 169

PROFIBUS DP Communication Module
SIRIUS 3RW44 manual
GWA 4NEB 535 2195-02 DS 06
8-45
The following messages can be entered:
Table 8-21: Log list messages - reading the trippings
ID No. Trippings - Messages
309 Contact block overload
317 Electronics supply voltage too low
319 No line voltage
324 Temperature sensor overload
325 Temperature sensor open
326 Temperature sensor short-circuit
327 Thermal motor model overload
334 I
e
limit value exceeded
335 I
e
limit value undershot
339 Motor stalled - switched off
341 Asymmetry switch-off
343 Ground fault switch-off
355 Process image error
365 Incorrect parameter value
ID number of the faulty parameter
1407 Electronics supply voltage too high
1408 No load
1409 Loss of phase L1
1410 Loss of phase L2
1411 Loss of phase L3
1421 Impermissible I
e
/ CLASS settings
1479 Phase angle control failure
1481 Line voltage too high
1482 Current range exceeded