Siemens SIRIUS 3RW44 - Page 236

General Technical Data
SIRIUS 3RW44 manual
10-18 GWA 4NEB 535 2195-02 DS 06
1)
Parameter motor left only possible in combination with slow speed.
Type 3RW44 .. Factory setting
Control times and parameters
Warnings / error messages (continued)
Temperature sensor
•Overload
• Wire breakage
• Short-circuit
Ground fault
• Detected
• Tripping
Connection break in manual operating mode
Max. number of starts exceeded
I
e
limit value over / undershot
Cool-down time
• Motor active
• Contact block active
Heatsink thermistor
• Wire breakage
• Short-circuit
Quick stop active
Contact block defective
Impermissible I
e
/ CLASS settings
No external start parameters received
PIO error
Control inputs
Input 1 Motor right parameter set 1
Input 2
No Action
Input 3
No Action
Input 4
Trip Reset
Parameterization options for control inputs 1 ... 4
No Action
Manual operation local operating mode
Emergency start
Slow speed
Quick stop
Trip Reset
Motor right parameter set 1
Motor left parameter set 1
1)
Motor right parameter set 2
Motor left parameter set 2
1)
Motor right parameter set 3
Motor left parameter set 3
1)
Relay outputs
Output 1 On-time motor
Output 2
No Action
Output 3
No Action
Output 4
Group error
Parameterization options for relay inputs 1 ... 3
No Action
PIO Output 1
PIO Output 2
Input 1
Input 2
Input 3
Input 4
Run up
Bypass operation
Coasting down
On-time motor
Command motor-on
Fans
DC braking contactor
Group warning
Group error
Bus error
Device errors
Power on
Ready to start
Motor temperature sensor deactivated deactivated
Thermo click
PTC type A