Siemens SITRANS FUS380 - Page 102

Parameter Default val‐
ue
Value
range
Access
level
Description
210 Path 1 alarm output enable Yes No, Yes R/W Select "Yes" to enable current alarm on alarm
output / call-up
211 Path 1 fault hours e.g. 36 h Read; Read Total hours fault active
212 Path 1 fault counter e.g. 4 0 to 65535 Read Total number of faults.
Valid only if alarm is enabled
213 Path 1 fault appears Last fault
appear date
dd-mm-
yyyy,
hh:mm:ss
Read Last time the fault appeared.
Valid only if alarm is enabled
214 Path 1 fault disappears Last fault
disappear
date
dd-mm-
yyyy,
hh:mm:ss
Read Last time the fault disappeared.
Valid only if alarm is enabled
215 Path 2 alarm output enable Yes No, Yes R/W Select "Yes" to enable active alarm on alarm
output / call-up.
Valid only for 2-path solutions
216 Path 2 fault hours e.g. 36 h Read; Read Total hours fault active.
Valid only for 2-path solutions and if alarm is
enabled
217 Path 2 fault counter e.g. 4 0 to 65535 Read Total number of faults.
Valid only for 2-path solutions and if alarm is
enabled
218 Path 2 fault appears Last fault
appear date
dd-mm-
yyyy,
hh:mm:ss
Read First time the fault appeared.
Valid only for 2-path solutions and if alarm is
enabled
219 Path 2 fault disappears Last fault
disappear
date
dd-mm-
yyyy,
hh:mm:ss
Read Last time the fault disappeared.
Valid only for 2-path solutions and if alarm is
enabled
220 Dual slope alarm output en‐
able
Yes No, Yes R/W Select "Yes" to enable active alarm on alarm
output / call-up
221 Dual slope fault hours e.g. 0 h 0 to 65535 Read Total hours fault active.
Valid only if alarm is enabled
222 Dual slope fault counter e.g. 0 0 to 65535 Read Total number of faults.
Valid only if alarm is enabled
223 Dual slope fault appears Last fault
appear date
dd-mm-
yyyy,
hh:mm:ss
Read First time the fault appeared.
Valid only if alarm is enabled
224 Dual slope fault disappears Last fault
disappear
date
dd-mm-
yyyy,
hh:mm:ss
Read Last time the fault disappeared.
Valid only if alarm is enabled
225 Parameter checksum alarm
output enable
Yes No, Yes R/W Select "Yes" to enable active alarm on alarm
output / call-up
226 Parameter checksum fault
hours
e.g. 0 h 0 ... 65535 Read Total hours fault active.
Valid only if alarm is enabled
227 Parameter checksum fault
counter
e.g. 0 0 ... 65535 Read Total number of faults. Valid only if alarm is
enabled
Parameter lists
A.3 Diagnostics
SITRANS FUS380/FUE380
102 Operating Instructions, 05/2018, A5E00730100-AE