Copyright Silca 2004 121
Operating Manual - English IDEA
7.2 M
AINTENANCE
OPERATIONS
• Cutter replacement
• Belt replacement and tension adjustment
• Fuse check and replacement
• Electronic circuit board replacement
• Keyboard/display replacement
• Access to back compartment
• Access to bottom compartment
• Sensor replacement
• Photocell replacement
• Brush replacement
• WIN-TRANSFER program for loading/updating the machine program
7.3 C
UTTER
REPLACEMENT
1) turn the machine off and unplug it.
2) remove the cutter protective shield (i) by loosening the screw (i2).
3) slide the cutter release rod (X) into the hole located on the left side of the machines cutter shaft chassis
(
fig. 131
).
4) loosen the cutter locking nut (turning it clockwise) with the socket wrench (X1) provided with the machine.
ATTENTION: the thread is left-handed (reversed).
5) replace the cutter, then tighten the nut (turning it counter-clockwise) and remove the rod from its hole.
6) place the cutters protective shield (i) back into position securing it with the screw (i2).
Fig. 131
ATTENTION: when replacing a worn cutter with a new one or with a re-sharpened cutter consult ch.5.20
"Gauging", page 73.
X1
X
i2
i
To Next Page
Loading...
