Silca Idea - Copy from ORIGINAL for FRONT STOP - FEMALE; Reading Keys with Front Stop (Double Bit, Single Bit - Female)

26 Copyright Silca 2004
IDEA Operating Manual - English
5.5 C OPY FROM ORIGINAL FOR FRONT STOP - FEMALE
Clamp: S100 A-B = indicates the clamp ( S100 ) into which the key must be fitted, and which jaw to use.
Stop 0 = reference or point for positioning the key on the reading clamp.
5.5.1 Reading keys with front stop (double bit, single bit - female)
1) Press on the grip lever of the fixed clamp (A) and fit the centring device (see table) so that it protrudes
towards the mobile clamp (B). Release the grip lever.
2) Press on the grip lever on the mobile clamp (B) and fit the key so that the hole in the stem is up against
the centring device. Release the grip lever.
3) Hold the key head with one hand and the end of the centring device with the other and push the key up
against the stop 0 (A).
4) The ideal position for the mobile clamp (B) is when there is a distance of 3 mm min. and 15 mm max.
between the bit and inner side of the mobile clamp (B) (see ch.5.5.2).
Press START to proceed with cutting the key (see ch.5.5.2).
Fig. 30
ATTENTION: make sure that the bit is up against the stop 0 (A).
ATTENTION: position the key so that the highest tooth is facing left, ensuring contact with the stop (0) on the
vertical side of the tooth.
5) start the reading process, which will take the reader along the path indicated by the broken line. At the end
of the cycle see the message on the display in order to continue.
KEY READING
Original on right
Clamp: S100 A-B Stop: 0
[START]
Reading in progress…
Data processing
in progress
Please wait…
CENTRING Ø STEM
Ø 4,5 mm from Ø 4 mm to Ø 5 mm
Ø 5,5 mm from Ø 5 mm to Ø 6 mm
Ø 6,5 mm from Ø 6 mm to Ø 7 mm