Silca Idea - Fiam Keys

38 Copyright Silca 2004
IDEA Operating Manual - English
5.11 FIAM KEYS
Fig. 49
(
*
) WITH OPTIONAL
E5
Centring device for FIAM keys (E5 - ID), used in cutting (install on the K1 tailstock) (Special Square Stem).
E6
Centring device for FIAM keys (E6 - ID), used in reading (install on the fixed clamp S100-A).
C
Adapter for FIAM keys (C - ID), used in reading (install on clamp S100 in the place of jaw B), (Square-Round
Stem and Special Square Stem).
When the machine requires (indicates on display) adapter
E5 or E6 or C , proceed in the way described in
the following examples:
- It is very important to distinguish the type of key to be copied:
- Choose
option 4 for keys with square stems; option 5 for keys with square and round stems; option 6
for keys with special square stems (step on tip).
- Choose
option 1 - Reading + Cutting
SELECT TYPE OF KEY
0 - Bit stop male
1 - Bit stop female
2 - Shoulder stop
3 - Pump
4 - Square-square tip
5 - Square-round tip
6 - Square-stepped tip
1 - Reading + Copying
2 - Cutting only
3 - Reading only
4 - Post-reading adj.
stem
SQUARE
stem
SQUARE-ROUND
stem
SPECIAL SQUARE
D726462ZB Adapters
OPTIONAL
**