Silca Idea - Page 41

Copyright Silca 2004 37
Operating Manual - English IDEA
To cut Muel keys, proceed as follow :
CUTTING MUEL PUMP KEYS
The key blank to be cut must be positioned according to
the parameters given on the display after selecting the
program involved; the type of Muel pump keys requires
the use of the
E4 adapter and the key reference on " Stop
0
".
Please follow the instructions below carefully, and
observe the order of operations.
1)Loosen the knob (T1) by turning it anticlockwise until
the rotating clamp (S1) can be moved to a convenient
distance for fitting the key).
2)Take the ‘T’ wrench (T4) from its seat and fit into the
screw (V1), then loosen until the jaws are fully open.
At the end of the operation do not remove the ‘T’
wrench from the screw (fig. 47).
Fig. 46
3)Fit the key blank into the adapter E4 so that the bit
stops butt against the
E4 adapter stops (P7) (fig. 46);
tighten the screw (P).
4)Fit the
E4 adapter, with the key blank in the rotating
clamp (S1) from the inside, take the adapter up to the
side of the self-centring jaws and slightly close the
grips on the rotating clamp with the ’T’ wrench (T4).
5)Move the rotating clamp S1 so that the adapter
E4
enters the tailstock K1.
6)Tighten the knob (T1). Use the T wrench (T4) to
tighten the screw (V1) first, then the screw (V2) (fig.
46). Replace the T wrench (T4) into its seat, lower the
mobile safety shield and begin the process with
START.
- To remove the key at the end of the cutting operation:
loosen the grub screw (P) and remove the key,
or carry out the operations described above, in
reverse order.
Fig. 47
- You can now press ENTER in order to make further
copies of the key.
- Select
STOP to quit.
Fig. 48
SSN 328 M1 Brass
Clamp: S1-K1 Stop:0
Cutt : 1.25 Adapt: E4
Pcs. = 1/1
Cutting in progress
Copy: 1 of: 1
Bit 1
Copy 1 of 1 finished
More copies ?
NO=Stop YES =Enter
Adapter E4
P
P7
E
3
T1
V1
V1
V2