Copyright Silca 2004 77
Operating Manual - English IDEA
5.22 A
DAPTERS
Scroll with the arrows.
[ENTER] = to view the adapter parameters.
Fig. 101
SHIFT + [arrow Up] increases the value within:
+300 hundredths of a mm or hundredths of a degree (axis B)
X/Y1/Y2 = +20 cent.
SHIFT + [arrow Down] decreases the value within:
- 300 hundredths of a mm or hundredths of a degree (axis B)
X/Y1/Y2 = - 20 cent.
CLEAR to zero the value
[ENTER] in the last field is used to quit the window and show the message requiring the editing to be saved:
Adapters
1: E1 - Mortice
1: E2 - Bit Stop Female
3: E3 - Pump (cutting)
4: E4 - Muel (Cutting)
5: E5 - Fiam (cutting)
6: E6 - Fiam (reading)
7: E7 - Pump (reading)
8: E8 - Muel (reading)
9: E9 - Chubb RKS (C)
10: E9 - Chubb RKS (R)
11: E10 - Small Bit (C)
12: E11 - Rear Stop (R)
13: E15 - Special Bit F (C)
14: E16 - Special Bit F (R)
Adapter
E1
Side: cutting
Adjustments: B=+00
X=+00 Y1=+00 Y2=+00
Save
adjustments ?
No=STOP Yes=ENTER
To Next Page
Loading...
