Silca Idea - Cutters

76 Copyright Silca 2004
IDEA Operating Manual - English
5.21 C UTTERS
Scroll with the arrows.
[ENTER] = to view the cutter parameters.
SHIFT + [ENTER] = to set the current cutter.
* = shows the cutter currently selected
SHIFT + [arrow Up ] increases the diameter within +20 hundredths of a mm
SHIFT + [arrow Down] decreases the diameter within - 20 hundredths of a mm
CLEAR to zero the value
[ENTER] in the last field is used to quit the window and show the message requiring the editing to be saved:
ATTENTION: when [STOP] is pressed the new measurements are not saved; the previous gauging values
therefore remain valid.
Cutter
1: PL 1.25 (0.492)
2: PL 1.00 (0.393)
3: PL 1.50 (0.590)
4: PL 1.70 (0.669)
5: PL 1.90 (0.748)
6: PL 2.00 (0.787)
01 * - PL 1.25
Thickness: 125
Diameter: 10000
Adjust. Diam.: +00
Save
adjustments ?
No=STOP Yes=ENTER