Silca Idea - Error Messages

114 Copyright Silca 2004
IDEA Operating Manual - English
6.2.10.2 ERROR M ESSAGES
These errors may occur when the machine gauging
procedure has not been successful.
Possible causes:
• The Z13 gauging disk has not been properly fitted.
• The Z12 gauging template has not been properly fitted.
The messages listed below appear when there has been a problem during or after updating the program in
the machine. Try updating or re-loading the machine internal software using the WINTRANSFER Program
or the SILCA KEY PROGRAMS.
• The ISO cutting function has not been found.
• Machine ID has not been programmed.
• The card uses a type of cut not run on the machine.
• The clamp is not in the machine archive.
• The cutter is not in the machine archive.
• The adapter is not in the machine archive.
ERROR 1
X AXIS no contact
made !
ERROR 1
Y AXIS no contact
made !
ERROR 1
B AXIS no contact
made !
ERROR 2
ISO Function
not defined !
See operating manual.
ERROR 2
MACHINE ID
not defined
See operating manual.
ERROR 2
Type of cut
not available !
See operating manual.
ERROR 2
Clamp not
available!
See operating manual.
ERROR 2
Cutter not
available!
See operating manual.
ERROR 2
Adaptor not
available!
See operating manual.