124 Copyright Silca 2004
IDEA Operating Manual - English
7.6 E
LECTRONIC
CIRCUIT
BOARD
REPLACEMENT
Proceed as follows:
1) turn the machine off and unplug it from its power supply cable.
2) remove the bottom panel (ch.7.9).
3) disconnect all cable connectors from the electronic circuit board.
Fig. 135
4) take the electronic circuit board off by unscrewing the (Y1) nuts
off (fig. 136).
5) mount the new electronic circuit board and re-connect all cables
(all cable connections are polarised therefore cannot be
connected incorrectly).
6) re-fit the bottom panel and re-position the machine on its
workbench.
7) turn the machine on and launch the WIN-TRANSFER program.
Fig. 136
Y1
To Next Page
Loading...
