Silca Idea - Small Bit; Double Bit Keys

Copyright Silca 2004 53
Operating Manual - English IDEA
5.13 SMALL BIT / DOUBLE BIT KEYS
Fig. 71
The set comprises :
E10 Adapter for small bit or double bit keys (E10 = ID initials), used for cutting.
E Adapter for small bit or double bit keys (E = ID initials), used for reading (to fit to the S100 clamp in the place
of jaw B).
When the machine requires (indicates on display) adapter E10 or E , proceed as follows:
- It is very important to distinguish the type of key to be copied: Choose
option 9 - Small bit .
Choose option 1 - Reading + Copying :
Operate as follows :
SELECT TYPE OF KEY
0 - Bit stop male
1 - Bit stop female
2 - Shoulder stop
3 - Pump
4 - Square-square tip
5 - Square-round tip
6 - Square stepped tip
7 - Rear stop
8 - Rear stop french
9 - Small bit
10 - Special bit female
1 - Reading + Copying
2 - Cutting only
3 - Reading only
4 - Post-Reading adj.
KEY READING
Original on right
Clamp: S100 A - E Stop: 0
[START]
max 4
max 18
max 12
max 4
max 18
max 12
max 12
NO!
D727711ZB Adapters
OPTIONAL