52 Copyright Silca 2004
IDEA Operating Manual - English
CUTTING
• CUTTING (Stop 0)
Raise the positioning plate (P) and fit the key blank into the rotating clamp (S1) from the front end (*). Place
the stem into the ‘V’ on the jaws of the K2 tailstock, taking care to keep the bit horizontal and the key stop up
against the stop (STOP 0) obtained by fitting the plate (P) up against the front end of the K2 tailstock.
Secure the key by tightening the jaw screw (W2) with the wrench (T4) (fig. 67).
Replace the plate (P) in position in seat 2 or 3.
Replace the (T4) wrench in its seat.
Fig. 69
NOTE: the key can be fitted into the S1-K2 clamp from the front or from the back, according to the
type of key
Fig. 70
Left blank Brass
Clamp: S1-K2 Stop: 0
Cutt.: 1.25
Pcsz. = 1/1 [START]
Stop
0
0
P
P
P
To Next Page
Loading...
