134 Copyright Silca 2004
IDEA Operating Manual - English
7.14 DIAGNOSTIC FUNCTION –
ERRORS
IN
: C
OPY
FROM
O
RIGINAL
ON
IDEA
On IDEA key-cutting machines the new upgrade of SKP and Wintransfer can be used to notify Silca
S.p.a. of any anomalies by simply sending a file.
If a key is not properly reproduced after reading it with the
Copy from Original
function, before carrying out
other operations (especially the reading of other original keys), proceed as follows:
- - Connect the PC to the key-cutting machine:
IDEA KEY-CUTTING MACHINE
:
• How to download a bit from IDEA with SKP
1) Launch the SKP program.
2) Go to the list of machines.
3) Select the Idea machine and click with the mouse on the "Edit" button (if an IDEA has never been
configured on SKP, do it by clicking with the mouse on the "New" button).
4) Click with the mouse on the "Sw upgrade" button (Wintransfer will be opened automatically).
5) Click with the mouse on the "Connection test" button (if the connection is OK, the "Bit download for after-
sales service" button will be enabled).
6) Click with the mouse on the "Bit download for after-sales service" button.
7) Select the path (e.g. disk C:\) and give a name to the file to be saved.
8) Click with the mouse on the "Save" button.
9) The bit will be downloaded from IDEA (approx. 1 minute) and at the end of the operation the monitor will
show a ‘saved’ message.
10) Send the file to Silca (the file will have the extension *.map) via e-mail to the address (service@silca.it
),
complete with the following information:
• How to download a bit from IDEA with Wintransfer
1) Launch the Wintransfer program.
2) Select the Idea machine and click with the mouse on the "Select" button.
3) Click with the mouse on the "Connection test” button (if the connection is OK, the "Bit download for after-
sales service" button will be enabled).
4) Click with the mouse on the "Bit download for after-sales service" button.
5) Select the path (e.g. disk C:\) and give a name to the file to be saved.
6) Click with the mouse on the "Save" button.
7) The bit will be downloaded from IDEA (approx. 1 minute) and at the end of the operation the monitor will
show a saved message.
8) Send the file to Silca (the file will have the extension *.map) via e-mail to the address (service@silca.it
),
complete with the following information:
SW Version of key-cutting machine
. . .
Description of problem
- The last tooth of bit 1 is missing,
or
- part of the bit has been cut on the stem
Errors on machine display
INTERNAL ERROR n° 11
SW Version of key-cutting machine
. . .
Description of problem
- The last tooth of bit 1 is missing,
or
- part of the bit has been cut on the stem
Errors on machine display
INTERNAL ERROR n° 11
To Next Page
Loading...
