Silca Idea - Options; Carriage Approach Speed; Rotating Speed; Serial Number

106 Copyright Silca 2004
IDEA Operating Manual - English
6.2 O PTIONS
Below are described all the steps necessary for choosing
options.
Select the function from the main menu by placing the
cursor on “6 – Options”.
Press [Down arrow key].
A list of machine OPTIONS will appear:
Place the cursor on the option required and press
[ENTER].
6.2.1 Serial number
The display shows the machine’s serial number, that
should correspond to the one stamped on the date plate
on the back of the machine.
6.2.2 Carriage approach speed
This is the speed at which the carriages move towards the
cutting area, before starting the cutting cycle
.
We recommend to operate the machine with the speed that
is set
. If required, the operator can adjust the carriage
approach speed from a minimum of 1000 to a maximum of
3000 by.
6.2.3 Rotating speed
This is the speed at which the rotating clamp move
towards the cutting area, before starting the cutting cycle.
We recommend to operate the machine with the speed
that is set. If required, the operator can adjust the carriage
approach speed from a minimum of 1000 to a maximum of
3000 by.
0 - Copy from Original
1 - Decode and copy
2 - Insert the Cuts
3 - Queue from PC >>
4 - Calibrations
5 - Maintenance
6 - Options
ENTER
1 - Serial No.
2 - Carriage speed
3 - Clamp rotation speed
4 - Preferences >>
5- Language
6- Keyboard inversion
7- Protected Systems
8- Bit width
9 - Check reading
Ser. n.: 153214523123
Model: IDEA
Keys cut: _ _ _
SW version. : _. _._
Carriage approach
speed = 3000
(1000 – 3000)
Clamp rotation
speed = 3000
(1000 – 3000)