Silca Idea - Correcting Bit Depth

Copyright Silca 2004 63
Operating Manual - English IDEA
Stop : to quit
Enter : to continue (confirmation)
5.15.3 Correcting bit depth
With the "CORRECTING BIT DEPTH" function a number of alterations can be made to measurements for
the cuts on all the teeth (on sides 1 and 2 for double bit keys) within the limits of min. -0.50 mm and max.
+0.50 mm
Fig. 90
Use SHIFT + [arrow Up] key for higher values (bit is cut less)
Use SHIFT + [arrow Down] key for lower values (bit is cut more)
Applicate
X specular
bit conversion ?
No=STOP Yes=ENTER
Bit Depth
Bit 1 = +00
Bit 2 = +00
[ENTER]=CONFIRM
Correcting Bit Depth
Bit 1 = +00
Bit 2 = +00
[ENTER] = CONFIRM
(+)
(-)
(-)
(+)
MEASUREMENT
READ
1st BIT
2nd BIT