Silca Idea - Machine Program Updates

Copyright Silca 2004 133
Operating Manual - English IDEA
7.12 B RUSH REPLACEMENT
1) open the rear compartment (ch.7.8).
2) unscrew the two brush caps (M4) (
fig. 153 ), remove and fit two new brushes.
3) replace the two caps (M4).
4) close the rear compartment.
5) carry out “TEST 13” to check proper operation.
Fig. 153
7.13 WIN-TRANSFER P ROGRAM FOR LOADING / UPDATING THE INTERNAL
MACHINE
PROGRAM
The machine is supplied with an internal program already loaded and tested in our workshops. The user
therefore does not need to carry out any operations.
Only in the situations described below can the WIN-TRANSFER program be used to re-start the machine.
The following is a list of situations where the use of the WIN-TRANSFER program is required.
• Replacement of the electronic board or loss of the internal machine program.
1) replace the board with a new one, if necessary.
2) install on your personal computer the latest version received of the WinTransfer program.
3) read the serial number on the data plate on the back of the machine and enter on the machine.
4) gauge the machine according to the instructions in the manual, as follows:
- gauge as explained in chapter "Machine zero points" - “Cutting Unit’ and ‘Reading Unit” in the user’s
manual.
At this point the machine is set up and ready for operation.
• SILCA update for the program or machine data
- install on your personal computer the latest version received of the WinTransfer program and follow the
instructions in the program.
M4