Silca Idea - Page 136

132 Copyright Silca 2004
IDEA Operating Manual - English
ATTENTION: do not touch the X and Y axes carriages and press
START.
10) press START
- the ‘machine’s zero’ settings are detected by electric
contact
- when this operation is completed, the machine’s display
will show the measured quotes.
ATTENTION: if the STOP key is pressed, the new settings will be
lost. If so, only the previous setting values will remain
valid.
11) press ENTER to save the settings .
12)
remove the (Z12) and (Z13) templates .
13)
proceed with setting the reading unit .
READING UNIT
1) Select ‘Reading unit ’ #2 .
2)
press ENTER.
3) install the (Z14) template (
fig. 153 ).
4) lower the protective shield and press START.
- the ‘machine’s zero’ settings are detected by the optical
reader.
- when this operation is completed, the machine’s display
will show the measured quotes.
ATTENTION: if the STOP key is pressed, the new settings will be
lost. If so, only the previous setting values will remain
valid.
5) press ENTER
6)
remove the (Z14) template .
-
the new setting has been made .
Fig. 152
Pos. sensors.
ICX=ON ICY=ON
See operating manual.
[START]
Zero detection
in progress !
Measurements read:
X=4444 Y=3333
Save data ?
No=STOP Yes=ENTER
ENTER
START
1 - Cutting unit
2 - Reading unit
Install the A & B clamps
and Z14 template.
See operating manual.
[START]
Zero detection
in progress !
Measurements read:
X=4444 Y=3333
Save data ?
No=STOP Yes=ENTER
ENTER
START
ENTER