Copyright Silca 2004 11
Operating Manual - English IDEA
2 TRANSPORT
ATTENTION: the key-cutting machine is easily transported and is not dangerous to handle. The packed machine
should be carried by at least two people.
2.1 P
ACKING
The packing for IDEA is designed to ensure safe transportation and to protect the machine and all its parts.
It comprises a pallet base (b) to which the machine is attached, and a cardboard box as a cover (a).
The machine is fixed to the base of the pallet with screwed down brackets that hold it firm into place. This
prevents the machine and its protective shield from any damage.
The closed packing is held in place by two straps which hold the cardboard box firmly on the pallet.
Symbols are printed on the outside of the cardboard box to give instructions and warnings for transportation.
Fig. 12
To prevent any damage to the machine it is advisable to save and use the brackets provided for future
transportation.
2.2 U
NPACKING
To remove the machine from the packing box:
1) cut the straps with scissors and remove
2) raise the top part of the cardboard box
3) loosen the screws, both on the front and back brackets that hold the machine to the pallet.
4) use the special spanner (provided in the tool kit), to loosen the nuts on the machine’s feet.
5) remove the metal brackets and re-tighten the nuts on the feet.
6) check the contents in the box, that should comprise with the following:
- 1IDEA key-cutting machine
- 1set of documents, including: an operating manual, a spare parts list and a guarantee
- 1power supply cable
- 1tool kit
NOTE: we strongly recommend you keep the packing intact for future transportation.
a
b
Keep dry
This side up
Handle with care
Use no hooks
To Next Page
Loading...
