Copyright Silca 2004 57
Operating Manual - English IDEA
5.14 SPECIAL BIT FEMALE KEYS
Fig. 81
The set comprises
:
E15
Adapter – Centring device (E15 = ID code), used for cutting (install on the K1 tailstock).
E16
Adapter – Centring device (E16 = ID code), used for reading (install on the S100 - A clamp).
When the machine requires (indicates on display) adapter
E15
or
E16
, proceed as follows:
- It is very important to distinguish the type of key to be copied:
- Choose
option 10 - Special Bit Female
.
Choose
option 1
– Reading + Copying:
SELECT TYPE OF KEY
0 - Bit stop male
1 - Bit stop female
2 - Shoulder stop
3 - Pump
4 - Square-square tip
5 - Square-round tip
6 - Square stepped tip
7 - Rear stop
8 - Rear stop french
9 - Small bit
10 - Special bit female
1 - Reading + Copying
2 - Cutting only
3 - Reading only
4 - Post-Reading adj.
KEY READING
Original on right
Clamp: S100 A - B Stop:0
Adapt. E16 [START]
Is adaptor E16
installed ?
No=STOP Yes=START
max 15 mm
max 31 mm
max 7 mm
E15 E16
D728717ZB
Adapters
OPTIONAL
To Next Page
Loading...
