Silca Idea - Page 119

Copyright Silca 2004 115
Operating Manual - English IDEA
• The clamp is not in the machine archive.
• The tailstock is not in the machine archive.
• The type of key associated to the cutting card has not
been defined.
When gauging the “Machine Zeros” lack of contact is
detected between the two templates used (ch. 6.1.1, page
89).
The message signals a reader malfunction or an obstacle
before starting the reading cycle.
Possible causes:
• the reader is not working; proceed with the Reader Test
in the Maintenance menu ->Test.
• Check that there is no material on the laser slide located
on the bottom of the reader bracket.
• the key used is too big or exceeds the dimensions
allowed for the type of key.
• an accessory or adapter has been fitted not required by
the selected operation.
The message indicates that the chosen cutter is not
suitable for cutting or copying the key, as its thickness is
greater than the minimum width of the teeth to be cut.
As current cutter select a cutter from those available in the
cutter archive with a thickness less than or the same as
that given in the message, with an overall tolerance of +25
hundredths.
Indicates that the reading of an ORIGINAL key has been
launched but the key is not in the reading clamp.
ERROR 2
Undefined
Clamp !
See operating manual.
ERROR 2
Tailstock
not defined !
See operating manual.
ERROR 2
Type of key
not defined !
See operating manual.
ERROR 10
Tem pl a te no
contact made.
See operating manual.
ERROR 11
Optical reader
is off
See operating manual.
ERRORE 12
Select the cutter
with max thickness: x.xx mm
[ENTER]
ERROR 13
Original key not
found