Silca Idea - Page 79

Copyright Silca 2004 75
Operating Manual - English IDEA
START = press START to begin the automatic gauging procedure for the CLAMP TAILSTOCK unit.
Template Z13 = fit in place of the cutter (fig. 100).
Template Z15 = fit on the S1-K2 clamp as if it were a key (fig. 100). Use the plate (P) as a point of reference
in position 2 with the second pin on the template up against it. Tighten the screw (W2) with the (T4) wrench.
Replace the (T4) wrench in its seat.
Fig. 100
Press START
Position the pointer at the side of the parameter to be edited with the arrow keys or [ENTER] and use the
following keys to edit the parameters:
[SHIFT] + [arrow up]:increases the value within
+ 300 hundredths of a mm or hundredths of a degree
(axis B)
+ 20 cent.mm X/Y1/Y2
[SHIFT] + [arrow down]: decreases the value within
- 300 hundredths of a mm or hundredths of a degree
(axis B)
- 20 cent.mm X/Y1/Y2
[CLEAR]:to zero the value
[ENTER]:in the last field to quit the window so that the query Save? appears for the edited data:
ATTENTION: if [STOP] is pressed the new measurements are not saved; the previous gauging values therefore
remain valid.
Clamps: S1 - K2
Adjustments: B=+000
X=+00 Y1=+00 Y2=+00
To calibrate [START]
Clamps: S1 - K2
Install Z15 and Z13
See operating manual
[START]
Clamps: S1 - K2
Detection
In progress
Clamps: S1 – K2
Adjustments: B=+000
X=+02 Y1=+02 Y2=+04
To calibrate [START]
Save
adjustment ?
No=STOP Yes=ENTER
W2
Z
13
P
Z15