Silca Idea - Page 78

74 Copyright Silca 2004
IDEA Operating Manual - English
Select S1:
Clamp: S1 - K1 = unit comprising clamp S1 and interchangeable tailstock K1.
SHIFT+ENTER = to go to the other interchangeable tailstock used with clamp S1, if applicable.
START = press START to begin the automatic gauging procedure for the CLAMP-TAILSTOCK unit, if
applicable.
Place the pointer at the side of the parameter to be edited with the arrows or with [ENTER] and edit the
parameters using the following keys:
SHIFT + [arrow Up] increases the value within:
+300 hundredths of a mm or hundredths of a degree (axis B) + 20 cent.mm X/Y1/Y2
SHIFT + [arrow Down] decreases the value within:
- 300 hundredths of a mm or hundredths of a degree (axis B) -20 cent.mm. X/Y1/Y2
CLEAR to zero the value
[ENTER] in the last field is used to quit the window and show the message requiring the editing to be saved:
ATTENTION: when [STOP] is pressed the new measurements are not saved; the previous gauging values
therefore remain valid
.
Fig. 99
Select S100
F OR K2 TAILSTOCK :
- Press [SHIFT + ENTER]
Clamp: S1 - K1 = unit comprising the S1 clamp and K1 interchangeable tailstock.
>> = press [SHIFT+ENTER] to go to the other interchangeable tailstocks used with the S1 clamp, if
applicable.
Clamp: S1 - K2 = unit comprising the S1 clamp and K2 interchangeable tailstock
Clamps: S1 - K1
Adjustment: B= +000
X=+00 Y1=+06 Y2=+06
To calibrate [START]
Save
adjustment ?
No=STOP Yes=ENTER
Clamp: S100
Adjustments:
X=+04 Y1=+04 Y2=+04
Clamps: S1 - K1 >>
Adjustments: B=+000
X=+00 Y1=+00 Y2=+00
To calibrate [START]