36 Copyright Silca 2004
IDEA Operating Manual - English
1)Loosen the screw (G) 1)on the S100 camp.
2)Pull out the mobile clamp unit (B).
3)Fit the
E8
adapter into the S100 clamp, then
tighten the screw (G).
4)Fit the original key into the adapter
E8
, so that
the stops on the bit butt against the stops (P6)
on the adapter
E8
and the cuts are directed
upwards. From this condition turn the knob (P5)
to turn the pin-cam securing the key.
5)Push the
E8
adapter until the side (Y) is butting
against the fixed part of the S100 - A clamp,
tighten the grub screw
(B9).
6)Press the START key to continue.
7)When the decode process starts the carriage
will take the key into contact with the laser beam
along an ideal path.
Fig. 44
Fig. 45
8)At the end of the cycle see the message on the display in order to continue.
Decoding in progress…
Bit 1
Bit 1
5 3 1 0 2 5 4 3 2 4
Possible depths:
0 1 2 3 4 5 [10]
B
G
B9
To Next Page
Loading...
