Silca Idea - Page 43

Copyright Silca 2004 39
Operating Manual - English IDEA
KEYS READING
READING SQUARE STEMMED FIAM KEYS
Operate as follows:
See Operating Manual, as for keys with front stop M.
Fig. 50
READING SQUARE AND ROUND STEMMED FIAM KEYS
Operate as follows:
1) Press the grip on the S100-B1 mobile clamp and
remove the adapter (jaw B).
2) Install jaw C so that the letter C is facing the
operator.
3) Open the fixed clamp (A) and the mobile clamp (C)
by exerting pressure on the jaw lever (F) and (F1).
4) Fit the key into the special groove taking the bit all
the way into the fixed clamp (A).
ATTENTION: position the key so that the highest tooth is
facing left, ensuring contact with the stop (0) on
the vertical side of the tooth.
5) Release the jaw lever.
6) Place the mobile clamp (C) in the best position on
the stem between the bit and key head. Make sure
that there is a distance of min. 3 mm and max. 15
mm between the bit and inside of the mobile clamp
(C) (the square part of the stem should butt against
jaw C).
7) When the reading process starts the carriage will
take the key into contact with the laser beam along
the path dictated by the Software.
At the end of the cycle see the message on the display
in order to continue.
Fig. 51
KEY READING
Original on right
Clamp:S100 A-B Stop: 0
[START]
KEY READING
Original on right
Clamp: S100 A-C Stop: 0
[START]
F1
F