Silca Idea - Page 132

128 Copyright Silca 2004
IDEA Operating Manual - English
Fig. 144
R EPLACING THE B AXIS SENSOR
1) turn off the machine and unplug.
2) raise the safety shield.
3) loosen the 2+2 locking screws, remove and withdraw the B axis carriage cover.
4) disconnect the sensor connector (M5) (fig. 145).
5) loosen the grub screw (M6) with the allen wrench provided.
6) remove the worn sensor and fit the new one so that it almost touches the bottom (fig. 147).
7) connect the sensor connector (M5). Carry out the B axis sensor Test: the state is OFF.
8) Use a screwdriver to turn the screw (M7) clockwise (fig. 146), the state changes to ON, tighten the grub
screw (M6).
9) Replace the B axis carriage cover.
Fig. 145
Fig. 146
Y axis sensor
0,1 - 0,4 mm
M6 M5 M7
M7
OFF
ON