Silca Idea - Page 134

130 Copyright Silca 2004
IDEA Operating Manual - English
R EPLACING CUTTER MOTOR PHOTOCELL
1) turn the machine off and pull out the plug.
2) remove the lower plate (see ch.7.9 "Access to bottom compartment", page 126).
3) loosen the 2 screws (G11).
4) disconnect the photocell wire (G8) (fig. 149).
5) loosen the 2 screws (G9) fixing the photocell and remove it.
6) connect the wire to the new photocell.
7) position the photocell and secure with the screws (G9) so that the disk (G10) is in the centre of the
photocell sensors.
8) tighten the screws (G11).
9) replace the lower plate.
10) connect the power supply wire and turn on the machine.
11) check with the cutter motor Test.
Fig. 149
Fig. 150
G8
G11
G10
G9