Copyright Silca 2004 69
Operating Manual - English IDEA
After entering the cuts for all the bits, go on to cutting.
M1
= bit 1
Clamp: S1- K1
= indicates which clamp (
S1
) and tailstock (
K1
) to use for gripping the key.
Stop 0
= reference or point for positioning the key in the cutting clamp.
Cutter: 1.25
= thickness of the cutter currently selected (press SHIFT+ENTER to change thickness)
Brass/Steel
= material of the key (press SHIFT+ ? to change material)
Pc. 1/1
= enter the number of keys required.
ATTENTION: always check that the wording BRASS/STEEL corresponds to the material of the key
SHIFT+ENTER = used to change the thickness of the current cutter by pressing ENTER against the cutter
thickness required:
Press STOP to quit.
Press START to begin cutting.
SSN: 9 M1 Brass
Clamp: S1-K1 Stop: 0
Cutter: 1.25
Pcs: 1/1 [START]
Choose cutter
1*: PL 1.25
2: PL 1.00
3: PL 1.50
To Next Page
Loading...
