Send waypoint
Select this option to allow this unit to send waypoints to another device via NMEA 2000.
Ú
Note: The system can only transmit or receive one waypoint at a time on creation of that
waypoint. For bulk import or export of waypoints see the operator manual.
NMEA 0183 setup
The NMEA 0183 port(s) must be set to suit the speed of connected devices, and can be
configured to output only the sentences required by listening devices.
Receive waypoint
Select this option to allow a device capable of creating and exporting waypoints via NMEA
0183 to transfer directly to this unit.
Baud rate
This should be set to correspond with devices connected to the NMEA 0183 input and
output. The input and output (Tx, Rx) use the same baud rate setting.
Ú
Note: AIS transponders typically operate at NMEA 0183-HS (high speed), and will require
the baud rate to be set to 38,400.
Serial output
Selection determines whether the data is output via Tx lines, and will enable editing of the
output sentences list.
Serial output sentences
This list allows control over which sentences that are transmitted to other devices from the
NMEA 0183 port. Due to the limited bandwidth of NMEA 0183 it is desirable to only enable
the data that is required. The less sentences that are selected, the higher the output rate of
the enabled sentences.
Ethernet/WiFi
The NMEA 0183 data stream is output and made available to tablet devices and PCs, via WiFi
or Ethernet connection. The dialogue provides IP and port data typically required for
configuring the application on the third party device.
Ú
Note: Other MFDs cannot decode this information back to NMEA 0183, to use the data
as a source. To share data a physical NMEA 2000 or NMEA 0183 connection is still
required.
System setup | NSS evo3S Installation Manual
39
To Next Page
Loading...
Need help?
General
