System setup
Turning the system on and off
The system is turned on by pressing the Power key.
Press and hold the Power key to turn the unit off.
If the key is released before the shut-down is completed, the power off process is cancelled.
You can also turn the unit off from the System Controls dialog.
Ú
Note: If the unit power is controlled by the power control wire, refer to power control
wiring for details about turning the unit on and off.
First time startup
When the unit is started for the first time, or after a reset, the unit displays a series of dialogs.
Respond to the dialog prompts to make fundamental settings.
You can perform further setup and later change settings using the system settings dialogs.
System setup sequence
1 General settings - refer to "System settings" on page 25.
• Make general settings as desired.
• Configure the power control.
2 Advanced settings - refer to "Advanced" on page 26.
• Enable or disable features.
• Review the advanced setting options and make changes as desired.
3 Source selection - refer to "Network settings" on page 37.
• Make sure that the proper external data sources have been selected.
4 Feature setup
• Configure specific features as described later in this chapter.
The settings dialog
The system setup is done from the settings dialog.
System settings
4
System setup | NSS evo3S Installation Manual
25
To Next Page
Loading...
Need help?
General
