Dock-to-dock Autorouting and Easy Routing examples
• Entire route option used when first and last route points are selected.
First and last routepoint Result after automatic routing
• Selection option used for autorouting part of a route.
Two routepoints selected Result after automatic routing
The edit route dialog
You can manage routes and routepoints, and change route properties using the Edit Route
dialog. This dialog is activated by selecting an active route's pop-up or from the menu by
selecting the route then the details option.
The dialog can also be accessed by using the Waypoints tool on the Home page and then
selecting a route in the dialog.
Select a routepoint in the edit dialog to insert a new routepoint after it or remove the
routepoint.
Select the display option to show the route on the chart.
Deleting routes
You can delete a route by selecting the delete menu option when the route is activated on
the panel.
You can also delete a route by selecting it in the routes dialog and then deleting it in the edit
route dialog.
You can delete all routes from the system using the routes dialog.
You can back-up your waypoints, routes and tracks before deleting them, refer to "Maintenance"
on page 144.
Tracks
Waypoints, routes, and tracks | NSS evo3S Operator Manual
43
To Next Page
Loading...
Need help?
General
